Undo Fasteners on Seat Pad and
Pull Headrest Pad Off Bottom of
Headrest
Unthread harness straps from slots
on side of headrest. Loosen harness
straps.
Pull chest clip, harness straps, and
buckle tongues out from behind the
headrest and seat pad.
Pull headrest pad down around
bottom of headrest.
Slide harness straps into slots in
headrest pad.
Attach seat pad fasteners.
67
1
Thread Buckle and Chest Clip
Harness strap ends go through the
back
of buckle tongues and through
the chest clip
front to back
as
shown.
If you have removed the harness straps from the splitter plate,
and the buckle tongues and chest clip have been unthreaded
from the harness straps, follow the steps below to rethread
them.
5
Adjust Headrest to Highest Position
68
Insert Buckle’s Metal Retainer into
Slot Closest to Child
Buckle
must
face out.
Rear-Facing Mode
: You
must
use the
1st or 2nd buckle slots.
Forward-Facing Mode
: Any slot can be
used.
Fully Recline the Car Seat
Pull out on recline handle and push top
of child restraint back.
Check Buckle
Pull up on buckle to make sure it is
secured.
The buckle
must
not pull out.
Reach Under Seat Between Base
and Shell and Through Recline
Handle
Pull metal retainer completely through
pad and shell.
1
3
1
2
3
2
4
Installing Harness System
continued on next page
6
