5
Hisselektronik
www.safeline.se
To program the telephone, a programming unit HT99-H is needed.
It is also possible to program the telephone by using a dial tone telephone,
or with our Window-based PC software Safeline Pro (can be down loaded at
no cost from our web-site
www.safeline.se
).
Programming with Safeline Hand Unit HT99-H
It is possible to register all alarm codes and telephone numbers long before
programming the telephone. The hand unit is battery powered and saves all
codes and numbers in the memory, even if the power is turned off
or the battery is changed.
SafeLine™ 1000 Programming
Step by
step…
The display
shows:
Explanation:
Next to do:
Tip:
Turn on the
power
Handunit for
Safeline 1000/2000
-----------------
Version 1.15
After about 3 seconds
the next text will show.
Step 2:
_
ALARM CODE 1 =
#=NEXT D=HELP
Type the 8-digits P100/
CPC alarm-code given
to you by your alarm-
receiving operator.
This is the “Primary
code”
This code is to be used
for lift alarm.
Press ”#” to go
to next text
Step 3:
_
ALARM CODE 2 =
#=NEXT D=HELP
Write the second 8-digits
P100/CPC alarm-code
given to you by your
alarm-receiving operator.
This is the “Secondary
code”
This code is to be used
for battery alarm.
Press ”#” to go
to next text
If you anytime between all
steps press “C” you will
continue directly to Step 15.
Step 4:
_
TEL.NUMBER 1 =
#=NEXT D=HELP
Write the 1:st telephone
number you want to call
in case of emergency
alarm.
Press ”#” to go
to next text
Phone numbers can be 16
digits long. “ * “ means 1
second pause. That can be
useful when calling through
a switchboard. Press B to
change alarmcode
Tel.nr1normally P100-
numbers
Programming with hand unit