9
Hisselektronik
www.safeline.se
Programming from a dial tone telephone:
It is possible to program the telephone by calling to it.
By using different dial tone commands it is possible to program all codes
and telephone numbers to the telephone.
This is how to do it:
If only one telephone is connected to the line:
Call the lift telephone. It will answer with 3 tones after 2 signals (this is
standard but can be changed to 0-16 signals).
If more then one telephone are connected to the line:
Call the alarm telephone. After 2 signals the telephone will answer
(always 2 signals when more than one connected lift telephone).
To get to e.g. telephone number 3, press “3” repeatedly until 3 distinctly
signals are heard and the connection is made.
Dial “00”, the lift telephone will answer with “OK” (2 short signals) or
“Wrong” (1 long signal).
Dial the password - * XXXX # where XXXX stands for the password. The
default password is “0000”.
The lift telephone answers with “OK” (2 short signals) or “Wrong” (1 long
signal).
Change codes and/or telephone numbers according to the below table.
There is a time span of 5 seconds between the digits, after that time there
will be a “Wrong” signal and the registration has to start all over again.
After 30 seconds without activity the lift telephone will disconnect the call.
After a successful registering the code/telephone number will be saved.
If there is a “Wrong” signal or if the call is disconnected, all successful
registering are saved.
Always discontinue the call: *00*#
1.
1.
2.
3.
4.
5.
6.
Dial tone programming