Airfield Lighting
Safegate Group
Manual
Date: October 2016
Ref: SL-RE-E_SL-RT-E_SL-RN-E_SL-RTN-E_SL-SB-E
Version: 1.4
Page 18 of 42
2.5
INSTALL/REMOVE ON/FROM A SUPPORT
Install the light fixture on a support
Image example
Before you start
Open the box and verify that the
characteristics of the light fixture
correspond to you design
requirements, such as: type, actual
installation position, colour, direction
and electrical supply.
FIGURE 14 - PREPARATION
1. Loosen (but do not remove) the
three setting screws (M6x20 mm) on
the fixture with an allen key.
2. Connect the light fixture cable (male)
to the power supply cable plug
(female).
3. Set the light fixture in correct
position,
see section 3.1 Set the
Light Fixture,
and fasten the three
setting screws using an allen key,
make sure to hold the light fixture in
its position when tighten the screws
so that it does not turn.
After installation, check that the light
fixture functions properly.
FIGURE 15 - PLACEMENT
Remove the light fixture from the support
1. Loosen (but do not remove) the three setting screws on the fixture with an allen
key.
2. Remove the light fixtures from its support.
3. Disconnect the light fixture cable from the power supply cable plug.
1
1
2
3
