© Safe Fleet | 2020 | All rights reserved | Part #: 700-1118 R2
TH4 Installation Guide
p. 23
TH4 Basic Configuration
Time/Display --> Monitor
Settings
If a Rear Vision Camera is installed, select monitor output settings.
Record
Set the Record Delay Off to 15-20 minutes for post trip check.
If Wi-Fi is used, set the Power Delay Off to 2 hours for archive download.
Record --> Camera
Turn off any unused camera channels, to avoid VLOSS events.
Alarms and Signals --> Alarms
Configure each alarm depending on source (Signals, Speed, G Sensor, GPS Fence,
Wake).
Alarms and Signals --> Signals
Configure which signals will trigger alarms. Excessive speed and G Sensor readings
can be set as signal outputs.
Alarms and Signals --> Speed
If the DVR is used in Canadian fleets, select the KPH speed units.
Alarms and Signals --> (TH4
external G Sensor)
If a G Sensor is installed, Calibrate.
Network
If Wi-Fi network is used, set addresses as instructed by administrator.
System
Select the audio channel to output from the DVR audio RCA socket.
If Diagnostic Indicator or RGY Illuminator is installed, select it here.
System --> Program Update
Upload DVR configuration if necessary.
Format the hard drive after all settings have been made.