R•O•M M4000 Power - Series IV Shutter Door
Installation Instructions
6800 East 163
rd
Street • Belton, MO • 800-827-3692
Copyright © 2022. All Rights Reserved.
Page
5
of
17
FM-8.5-384 / D / 06-24-2022
8. Installing the Power Lock
a) Mount the power lock to the track if not factory
installed. The track will be pre-drilled and slotted
for the power lock. Mount the lock using 3/16” pop
rivets as shown in Fig. 8. Recessed track will
have mounting brackets for the power lock to be
mounted to.
b) Ensure the lock pawl moves freely after mounting.
c) Route the power lock wires to the power door
control module using care to protect the wires.
Connect the light green and orange wire from the
power lock to the light green and orange wire on
the power door control module. If two locks are
used connect all wires together.
9. Installing the Proximity Switch
a) Place the end of curtain travel proximity switch 2-
3/4” from
the top of the track to the bottom of the switch and 2-
3/4”
from the bottom of track to the top of the proximity switch.
This distance should be increased to 3-
1/4” when a bottom
rail extension is used and 4-
1/4” for the tall bottom rail. See
Fig. 9 for an example of where the proximity switch is
located with conventional track. Temporarily install the
switch in the track with silicone or some other temporary
substance.
b) The proximity switch is normally open. When the magnet on
the bottom rail passes over it while opening or closing the
door it signals the power module to shut the power off to the
motor. The signal from this switch can also be used to
provide power to the door ajar/compartment light switch
provided by others (see wiring diagram-white wire). With
this being known, connect the compartment light and power
to the control module temporarily install the track and test
this function. If the light fails to turn on when the door opens
the proximity switch will need to be adjusted.
Use silicone to permanently secure the proximity switch to the track.
10. Attaching the Track
a) While tilting the bottom rail outward slide the track onto it.
b) Rotate the track toward the vehicle body and attach with the recommended fasteners, including the
installed power lock.
Fig.8
Fig. 9
