R•O•M M4000 Power - Series IV Shutter Door
Installation Instructions
6800 East 163
rd
Street • Belton, MO • 800-827-3692
Copyright © 2022. All Rights Reserved.
Page
16
of
17
FM-8.5-384 / D / 06-24-2022
6. Replace the tension pin and re-attach the straps to the top slats.
7. Remove the tension pin and slowly let the tension onto the shutter. Route the curtain over
the nylon rollers and raise the curtain up to the header. Re-install track.
III.
SLAT REPLACEMENT
If the R•O•M Shutter needs slats replaced, they
can be replaced with the slats that are non-
visible (Ref. Fig. 2). Do not use the first slats
closest to the operator for they have been
specifically cut to accommodate the t-clips.
Before you begin
This procedure requires that you lay the curtain and track on its face. Always remember to protect the
face of the curtain and any other visible parts.
1. To remove the drip rail assembly, refer to step 13 to see how it was installed.
2. To remove the track assembly, refer to step 11 to see how the track was installed. Remember to
remove the sealant used to seal the track. This
will ensure that the new sealant will adhere
correctly during the track reinstallation.
3. To detach the curtain assembly, refer the step 8
to see how the curtain was attached. Once the
curtain assembly has been detached you will
need to lay it on its face using a blanket, rug,
towel, or any other kind of soft material that will
prevent the curtain from being scratched.
4.
To remove the end shoes, grasp the middle of
the end shoe with a vise grip and twist out until
the end shoes slides out of the end of the slat.
(See Fig 3.)
5. After removing the end shoes on both sides
slide out the damaged slat and the hidden slat.
Replace the damaged slat with the hidden slat
and reassemble.
Non-visible slats
OUTSIDE
Visible slats
Ref. Fig. 2
GRAB HERE
TWIST
Ref. Fig. 3
