SafeTrack – Hardware Installation Guide
9
5. Reach behind the mounting surface and use a hex nut to tighten
the LED and the Bezel against the mount surface.
6. Make sure the Bezel is properly oriented and the mounting holes
align with the holes drilled for mounting.
7. Fasten the Bezel to the mount surface with screws.
4.2 Electrical
The LED pigtail has 4 wires
• 3 wires that are to be connected to positive outputs on the Hub IO
connector
• 1 Wire that is to be connected to the ground Pin on the Hub IO
connectors
The Hub IO Connector
• Is a 6 pin Deutsch connector (socket) for IO and ground.
• A pig tail with a 6 Pin Deutsch connector (plug) is supplied with
the Hub.
Connect the wires from the Deutsch connector (plug) on the Hub to
the wires from the LED as follows. (Refer to diagram below)
• PIN 3 Red LED Output 1
• PIN 4 Green LED Output 2
• PIN 5 White LED Output 3
• PIN 6 Ground