SafeTrack – Hardware Installation Guide
14
7 INSTALLING THE SAFELINK TAG
Tags are mounted onto equipment that need to be tracked. Tags may
be mounted using one of the following options, depending the on the
equipment/asset being tagged
1. Drill and Tag Hole
2. Secure Tie
3. Adhesive
Assist groove for
door release
Through hole for screw
or secure tie
Through hole for screw
or secure tie
Alignment Arrow Etch
Prior to Mounting
Make sure that
1. The battery isolator has been removed from the underside of the
CR2032 coin cell battery that powers the Tag.
2. The battery is properly installed with the positive side facing the
back cover or battery door of the Tag.
3. The orange gasket around the battery holder hole should not be
visible after the battery door has been placed back.
4. The battery compartment closed by rotating the door such that
the etched arrows on the battery door line up with the two arrows
etched on the Tag body.
5. Note the ID number of the TAG as it may be needed at a later point
for registering the Tag (logically linking it to the asset in software)
