SafeTrack – Hardware Installation Guide
13
6.2.1 Mechanical Install Procedure
Access Available Behind Mount Wall
1. Drill two holes that adhere to the dimensions of the RELAY in terms
of location and size of holes.
2. Use bolts to mount the RELAY to the wall.
3. Secure the bolts with plain or nylon nuts and a lock washer screwed
on from the opposite side of the wall.
Access NOTE Available Behind Mount Wall
1. Drill and tap two holes, that adhere to the dimensions of the RELAY
in terms of location and size of holes.
2. Use a size # 6-32 tap to drill the hole.
3. Mount the RELAY to the wall and secure using screws through the
holes.
6.3 Electrical Install
The SafeTrack Relay comes into version
• Battery Power (2 X Type D battery)
• Power from Vehicle Over Harness.
The following applies to the second version.
The Relay wiring harness includes a two pin Deutsch connector for
power and ground
1. Connect the Relay power pin to power rail on the Vehicle that
supplies 12 VDC.
2. Connect the ground pin to vehicle chassis ground.
Important: Be careful not to connect the ground pin to a location
where there may be large inductive devices, such as a ladder
rack motor.
