User Guide
“CFOL Series”, User Guide
© SAF Tehnika A/S 2009
6
1.1.3 Wireless
Wireless link status - displays the status of the Wireless link. A State
UP
indicates that
the Wireless link between local and remote units is established. A state
DOWN
indicates
that the Wireless link between local and remote units is not established.
Operating mode - displays the operating mode of the device. The operating mode can
be Master or Slave.
Link ID - displays point-to-point link ID, specified by the user.
Encryption - displays encryption method: none or AES.
Peer MAC - displays MAC address of the remote unit.
Frequency, MHz - displays frequency in MHz at which the point-to-point link
communicates.
Channel width, MHz - displays the channel width (5/10/20/40) at which the point-to-
point link communicates.
Data rate, Mbps - displays data rates at which the point-to-point link communicates.
Antenna gain, dBi - displays device radio antenna gain in dBi.
Transmit power, dBm - displays TX power value of the local point-to-point unit.
Remote transmit power, dBm - displays TX power value of the remote point-to-point
unit.
Management packet rate, Mbps - displays administrator defined maximum count of
frames in transfer block between point-to-point units.
Transmit queue length, frames - displays administrator defined transmit queue length
in frames between point-to-point units.
Aggregation limit, bytes - displays administrator defined maximum packet count in
bytes to be aggregated in one frame.
Aggregation limit, packets - displays administrator defined maximum packet count to
be aggregated in one frame.
Link state - displays the state of the wireless link between point-to-point units:
Initiating - displays amount of time the device was in initiating state from the last
reboot.
Scanning - displays amount of time the device was in scanning state from the
last reboot.
Authenticating - displays amount of time the device was in authenticating state
from the last reboot.
Associating - displays amount of time the device was in associating state from the
last reboot.
Running - displays the time, expressed in hours, minutes and seconds since the
system was last rebooted.
