INTEGRA-W/INTEGRA-WS User Manual INSTALLATION
SAF Tehnika JSC
11
1
Using 13mm wrench slightly loosen three hex
flange bolts [1] and hex flange bolt, nut and eye
screw [2] interconnecting clamps for housing
and pipe [5].
2
Attach vertical alignment eye screw [3] to clamps for
housing and pipe [5] using hex flange bolt [8] and
screw on one hex nut [7] and two hex flange nuts [6].
Make sure that both eye screws are positioned as
shown in the image (turned to the back side of
clamps) and the gap between each two flange nuts on
eye screws should be 15..20mm (0.6..0.8 in.). Do not
tighten both hex flange bolts [8] and [2].
3
Screw on one hex flange nut [6] on each of
threaded rods [4]. Note that flange nuts should
be screwed on exposing approx. 20mm (0.8
in.) of threaded rods.
4
Insert both threaded bolts into two available holes of
mounting clamp. Put hex nuts [7] on the other side of
the clamp and screw on the threaded bolts until it is
visible from other side of the clamp not more than
2mm. Tighten hex flange nuts [6] with torsion 20..25
N·m.
5
Attach mounting bracket clamp [9] on longest
threaded rod [4] as shown on the picture and
afterwards screw on remaining two hex flange
nuts [6] on both threaded rods. No parts
should remain left not assembled.
Bracket clamps in following position support
mast
∅
55..120mm. Reversing clamps allows
support of smaller masts
∅
25..75mm.
6
Unscrew hex flange nut [6] from shortest threaded rod
[4]. Make sure that hex flange nuts on longest
threaded rod is not too far; otherwise adjust nut’s
position accordingly. Put other end of mounting
bracket clamp [9] on free threaded rod and screw on
hex flange nut.
7
Hex flange nuts should be evenly aligned on
threaded bolts so that mounting bracket clamp
[9] is tightly attached to the pipe. Tighten hex
8
View of assembled mounting bracket on the mast
pole.
