SK RB/RLB 9022WI with WABCO PAN 22-1
11.427GB Edition 11/09
-
29
-
4.5
Brake Pad Replacement
Caution: Do not use power wrenches! When working on the brakes or
when shifting the brake calliper, hold with your hands only on the
outside in order to avoid crushing of the fingers between brake calliper
and brake carrier!
Disconnect the plug from the wear indicator 64.3 (arrow).
Loosen screw 63.2 of pad holder bracket 63.1 using a spanner
(Table 1, position II) and remove the screw.
Pull pad holder bracket 63.1 out of the brake calliper.
Remove three spring clips 64.2 from brake pads 64.1 and pressure
plate 64.5.
Remove wear indicator 64.3 with sensors from the brake pads.
Remove both cable clips 64.4 from the brake calliper.
Remove plug 65 for adjuster 65.1 from brake calliper.
Turn back the brake at the hexagon of the adjuster 65.1 using a ring
spanner, then loosen again by approx. 1/4 rotation.
Note:
The adjuster is turned back by turning the spanner to the right, i.e. in
clockwise direction.
Caution: During backing off, the pressure plate 64.5 must be pushed
back by hand at the same time so that the pin serving as twist lock for
the adjusting pin does not slip out of the retaining groove. Otherwise
there is a risk of the adjusting pin also turning and destroying the
protective cap!
Installation instructions – PAN 22-1
Fig. 9
Fig. 10
Fig. 11
Fig. 12
63.2
63.1
64.3
64.5
64 1
64.2
64 1
65.1
65
64.4
64.3
