21
Precautions and warnings “during the use” of equipment
- The equipment should only be operated by duly enabled and trained technicians (Dental Surgeons,
Capacitated Professionals).
- If any maintenance should be required, only use services of the Alliage Authorized Technical
Assistance.
- The equipment has been manufactured to handle both continuous and intermittent operation; so
follow the cycles described in these Instructions for Use.
- Although this equipment has been planned in accordance with the standards of electromagnetic
compatibility, it can, in very extreme conditions, cause interference with other equipment. Do not
use this equipment together with other devices very sensitive to interference or with devices which
create high electromagnetic disturbance.
- Do not expose the plastic parts to contact with chemical substances, use in the routines of dental
treatment, such as: acids, mercury, acrylic liquids, amalgams, etc.
- Never block the ventilation openings of the device. Keep openings free of lint, hair and other
materials.
- Do not use the product without filling the tank with water. The dry running can damage the unit.
- Do not fill the tank above the maximum to avoid overflow.
Alliage shall not be responsible for:
- Use of the equipment differing from that for which it is intended.
- Damages caused to the equipment, the professional and/or the patient by the incorrect installation
and erroneous procedures of maintenance, differing from those described in these Instructions for
use which come with the equipment or by the incorrect operation of it.
PRECAUTIONS, RESTRICTIONS AND WARNINGS
Grounding is compulsory, only this way the user will be completely safe. It is only the user's
responsibility not to ground, implying in the loss of warranty. Use threepin outlet. Never
connect the grounding to the neutral.
Precautions and warnings “after” the use of equipment
- Turn off the main switch of the dental set when it is not in use for an extended period of time.
- Always maintain the equipment clean for the next operation.
- Do not modify any part of the equipment. Do not disconnect the cable or other connections
without need.
Precautions and warnings during the “cleaning and disinfection” of equipment
- Before cleaning the equipment, turn off the main switch.
- Avoid spilling water or other liquids inside the equipment, which could cause short circuits.
- Do not use microabrasive material or steel wool when cleaning, or employ organic solvents or
detergents which contain solvents such as ether, stain remover, etc.
- Use enzymatic detergents during the process there is no contraindication of it.
- When cleaning of silver or copper, where the effect of oxidation caused a blackout, you must add
special solutions to the water to remove rust.
