Saeco 10003064, Operating Instructions Manual

Page: 34 / 96

• 34 • • 34 •
• The machine begins the dispensing
phase. The “ ” icon will be displayed
to show which button is being pro-
grammed.
• Press the button with the “ ” icon
again when the desired amount of
coff ee in the cup is reached.
At this point the button “ “ is pro-
grammed; each time it is pressed and
released, the machine will brew the
same amount of coff ee that was just pro-
grammed.
Stand-By
The machine is designed for energy sav-
ing. The machine automatically turns off
after 60 minutes of inactivity.
Note: During the switching
off phase, the machine per-
forms a rinse cycle, if a coff ee product
has been brewed.
To turn the machine on again, simply
press the ON/OFF button (if the power
switch is set to “I”). In this case the ma-
chine will go through the rinse cycle only
if the boiler is cold.
COFFEE BREWING
Note: Should the machine not
brew coff ee, make sure that
the water tank contains water.
Before brewing coff ee, check
the messages on the display.
Check that the water tank and coff ee
been hopper are full.
Leave the dial on the coff ee
position
“ ” during the dis-
pensing phase.
Before brewing the coffee,
adjust the height of the brew-
ing head according to your needs, and
select the aroma or the pre-ground
coff ee.
Green
Green
bean hopper.
Do not pour coff ee beans when the
coff ee grinder is working.
The machine allows slight adjustments to
the coff ee grinder to adapt it to the kind
of coff ee used.
To make any adjustment, press and turn
the knob inside the coff ee bean hopper.
Press and turn the knob by one notch at
a time and brew 2-3 cups of coffee; this
is the only way to notice differences in
grind.
The reference marks inside the coffee
bean hopper indicate the grind setting.
There are 5 different grind settings to
choose from with the following refer-
ences:
Large Dot - Coarse Grind
Small Dot - Fine Grind
Green
Adjusting the Coff ee Quantity
The machine allows you to adjust the
amount of brewed coffee according to
your tastes and/or the size of your cups.
Each time you press and release button
“
“ or “ “, the machine brews a
pre-programmed amount of coff ee. This
amount may be reprogrammed to your
taste. Each button may be individually
programmed for a specifi c brew setting.
As an example, the following procedure
describes the programming of the button
“
“, which is normally associated with
espresso coff ee.
• Place a cup under the dispensing
head.
• Press and hold the “ “ button, until
the relevant icon is displayed. At this
point, the machine is programming it.
Black