SOUTHERN AVIONICS COMPANY
SE Series Installation and Setup
6-1
System Site Configuration
6 System Site Configuration
6.1 Control Program Initialization
Once the SE125 has been installed, the system is ready for operation. The unit is powered on by
the AC power switch located on the Power Control Panel. Actuating this switch begins the
initialization process. The SE125 will proceed through two initialization screens on the LCD
indicating which version of firmware is being used. When communicating with the factory, please
have the version available. The system will default to transmitter 1 as primary transmitter, LCD
data on TX1, Monitor Enabled, FWD POWER meter, PA VOLTS meter, and System Status as
primary. All other functions are turned OFF. The initialization screens are as follows:
Or
SE125
Southern Avionics Company
Beaumont Texas USA
Firmware Version X.XX © 2010
SE125
Initialization System
Please wait …
MM-DD-YYYY
SE SERIES [DUAL] Fault: NONE
RF Frequency Setting ......... 320000 Hz
Tone Frequency Setting ....... 1020 Hz
Call Sign: SAC TX Mode:IDENT
SE SERIES [SINGLE] Fault: NONE
RF Frequency Setting ......... 320000 Hz
Tone Frequency Setting ....... 1020 Hz
Call Sign: SAC TX Mode:IDENT