EN
Read the user manual.
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Risk of electric shock
Do not use in rain
Indoor use only
Class II machine - Double insulation -
You don’t need any earthed plug.
Max temperature 40
0
C
Do not throw the battery into fire
Do not throw the battery into water
Do not dispose of the product in
unsuitable containers.
Separate collection for Li-ion battery.
The product is in accordance with the
applicable safety standards in the
European directives.
a) This power tool is intended to function as a
grinder, sander, wire brush, polisher,
carving or cut-off tool. Read all safety
warnings, instructions, illustrations and
specifications provided with this power
tool.
Failure to follow all instructions listed below
may result in electric shock, fire and/or serious
injury.
Operations for which the power tool was not
designed may create a hazard and cause
personal injury.
b) Do not use accessories which are not
specifically designed and recommended by
the tool manufacturer.
Just because the accessory can be attached
to your power tool, it does not assure safe
operation.
c) The rated speed of the grinding
accessories must be at least equal to the
maximum speed marked on the power tool.
Grinding accessories running faster than their
rated speed can break and fly apart.
d) The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool.
Incorrectly sized accessories cannot be
adequately controlled.
e) The arbour size of wheels, sanding drums
or any other accessory must properly fit
the spindle or collet of the power tool.
vely and may cause loss of control.
Accessories that do not match the mounting
hardware of the power tool will run out of
balance, vibrate excessively and can lead to
loss of control of the power tool.
f) Mandrel mounted wheels, sanding drums,
cutters or other accessories must be fully
inserted into the collet or chuck.
If the mandrel is insufficiently held and/or
the overhang of the wheel is too long, the
mounted wheel may become loose and be
ejected at high velocity.
g) Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
sanding drum for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run the
power tool at maximum no-load speed for
one minute.
Damaged accessories will normally break
apart during this test time.
h) Wear personal protective equipment.
Depending on application, use face shield,
safety goggles or safety glasses. As
appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments.
