EN
b) Use power tools only with specifically
designated battery packs.
Use of any other battery packs may create a
risk of injury and fire.
c) When battery pack is not in use, keep it
away from other metal objects, like paper
clips, coins, keys, nails, screws or other
small metal objects, that can make a
connection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fire.
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If
contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help.
Liquid ejected from the battery may cause
irritation or burns.
Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts.
This will ensure that the safety of the power
tool is maintained.
For the charger
Intended use
Charge only CDA1094 type rechargeable battery
packs. Other types of batteries may burst causing
personal injury and damage.
a) The appliance is not to be used by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or
instruction.
b) Children being supervised not to play
with the appliance
c) Do not recharge non-rechargeable
batteries!
During charging, batteries must be placed
in the well-ventilated area!
Electrical safety
When using electric machines always observe
the safety regulations applicable in your
country to reduce the risk of fire, electric shock
and personal injury. Read the following safety
instructions and also the enclosed safety
instructions.
Always check that the power supply
corresponds to the voltage on the
rating plate.
Your machine is double insulated,
therefore no earthwire is required.
3. Assembly of accessories
Always remove the battery before
mounting an accessory
Warning! Change accessories by
inserting an accessory into the collet
(or chuck) as far possible to minimize
run out and unbalance.
Assembly of accessories
Fig. 2
Press down the axle locking button (3) and
hold it down. Using the spring chuck spanner,
you can undo the spring chuck (1). Put the
accessory in its place. Hold down the axle
locking button when you fasten the spring
chuck with the spring chuck spanner.
Operation
Switch on the machine by engaging the on/out
switch (5) By adjusting the adjusting wheel (4)
you can regulate the speed of the Rotary tool.
Do not put the machine down when the motor
is still running. Do not place the machine on a
dusty surface. Dust particles may enter the
mechanism.
Too high a load at a low speed of the
Rotary tool can burn out the engine.
The battery must be charged before firstuse.
Removing the battery from the machine
•
Push the battery unlock buttons and pull the
battery out of the machine
