![background image](http://html.mh-extra.com/html/sabo/js63-vario/js63-vario_operators-manual_795068065.webp)
9
GB
Handle starter assembly (Illustration D + L1 )
– The safety control bracket (A) on the upper handle must be folded down before the starter cable can be suspended.
– Pull out the starter cable (B) slowly and fit in the starter handle mount (C) with a twist motion.
To lock and unlock front wheels (JS63 VARIO C) (Illustration T3 )
NOTE
Front wheels will not lock when mower is on an even surface. To lock front wheels, push the mower in the garden.
Lock front wheels by mowing on a slope or uneven surfaces, or by pulling mower backwards away from wall or out
of narrow space.
– Push mower forward on an uneven surface.
– Pull lever (A) backward to lock position (B).
– To unlock front wheels push lever (A) forward to unlock position (C).
Adjusting the cutting height
Safety instruction!
See table for explanation of symbols page 3
Adjusting front wheel height
JS63 VARIO
A height adjustment lever on left front wheel adjusts both front wheels.
– Move height adjustment lever to desired position.
JS63 VARIO C (Illustration U3 )
– Move height adjustment lever on both front wheels to desired position.
Adjusting rear wheel height (Illustration V3 )
A height adjustment lever on left rear wheel adjusts both rear wheels.
– Lift the mower at the lower handlebar slightly with one hand to take some weight off wheel.
– Move height adjustment lever to desired position with other hand.
NOTE
Adjust all levers to same height except for two lowest cutting heights (A and B on following chart). At two lowest
cutting heights, raise rear lever one notch higher than front lever.
This setting optimises airflow during discharge and provides optimal cutting in the mulching process.
Begin with a higher setting, then adjust downward as desired, to avoid scalping lawn with too low a setting.
Key
Cutting Height Adjustments in mm
(A) 20
mm
(B) 33
mm
(C) 45
mm
(D) 59
mm
(E) 70
mm
(F) 85
mm
(G) 97
mm
Adjusting handle height (Illustration W3 )
NOTE
Lower handle height can be independently adjusted to three positions.
– Remove knurled nut (A) and bolt (B) on each side of handle.
– Pivot handle to the desired height (C).
– From inside pull the bolt (B) through the bracket and lower handle and screw tight with the knurled nut (A). Use the
same opening in the bracket on both sides.
Summary of Contents for JS63 VARIO
