7
11
Procedure - Installing the new Control Panel
•
Rotate the Control Panel into position, raised above
the locking tabs.
•
While holding the Control Panel in place against the
front of the Grill, slide the Control Panel down while
ensuring it engages the locking tabs.
•
Gently pull the top of the Control Panel forward to
confirm the locking tab engagement.
Be sure the top of the Control Panel engages
the locking tabs. If needed, open the tabs
slightly with a flat blade Screwdriver.
1
2
2
Locking tab
Shown fully
Engaged
•
Using your Phillips Screwdriver, reinstall the two #8
sheet metal Screws through the lower tabs of the
Control Panel and into the Grill Frame.
•
When you are finished with this step - the Burner
Tubes should be properly aligned to the Valves as
shown here:
12
You will now reinstall the Bezels and Control Knobs. Be
sure to complete each Bezel and Knob before moving to
the next one. This will keep the Manifold properly
attached to the rear of the Control Panel.
•
Using a Phillips Screwdriver, remove the two #8 Machine
Screws and Washers (if provided) from the Control Panel.
•
Position the Bezel on the Control Panel with the Valve Stem
in the center of the Bezel, as shown at right.
•
Reinstall the Screws and Washers (if provided).
•
Align the Control Knob to the Valve Shaft and firmly press
into place.
•
CAUTION:
Do not rotate the Knobs clockwise past the
OFF
position to avoid damage to the Valves.
•
Repeat this step for each Control Knob on your Grill. If your
Grill has a Side Burner,
DO NOT
reinstall the Control Knobs,
you will be replacing the Side Burner.
13
Proper Bezel-to-Valve
Stem Alignment
Shown rotated to allow
for a larger image.
The lower tab holes should now be
aligned with the Screw locations in
the frame.
© Saber Grills, LLC
Printed in U.S.A.
sabergrills.com
80028080
●
09/13/17
●
Revision 03
