3
Procedure - Removing the Existing Control Panel
•
Remember, the Doors are not shown.
•
Using your thumb, press
UP
on the face of the
Thermometer.
•
You will feel the Thermometer snap loose.
•
Pull the Thermometer away from the Control Panel.
•
Place the Thermometer in a secure place for
reinstallation later.
•
Repeat this step for each Thermometer on your Grill.
2
•
Remove all Control Knobs by pulling them straight
away from the Control Panel. The Knobs may be
tight and require increased effort to remove them.
•
Perform the following
ONE
Knob at a time.
•
Using a Phillips Screwdriver, remove the two #8
Machine Screws and Washers (if provided) and
keep the Control Knobs and Bezels in a secure
place for reinstallation later.
•
Reinstall the two Screws and Washers (if provided)
back in the location from where they were removed.
This will hold the Manifold in place until all Bezels
are removed. This is shown in the inset image.
•
Repeat this step for each Control Knob on your Grill
including your Side Burner, if your Grill is so
equipped.
3
Control Panel
Press UP
4
NOTE
- if your Grill
DOES NOT
have a Side Burner -
then this step will not apply. You may skip this step.
The Gas Manifold is connected to the Side Burner
with a Quick-Disconnect type fitting. Slide the Quick-
Disconnect back and while holding it back, pull the
Hose away from the Fitting.
1
1
2
CAUTION:
Do not rotate the Knobs
clockwise past the
OFF
position
to avoid damage to the Valves.
© Saber Grills, LLC
Printed in U.S.A.
sabergrills.com
80028080
●
09/13/17
●
Revision 03
