8
Tools and Safety Equipment Recommended -
Side Burner Replacement
NOTE:
Some Tools are not included. You will need the 7/16” socket tool (included) to complete the replacement of the Side
Burner. This Tool is needed only for the replacement of the Side Burner. Wear Gloves to protect your Hands during the
replacement procedure.
These symbols mean to use
caution and to wear your Goves.
•
Remove your Cooking Grates for this step.
•
Insert your Thermometers, one at a time into the
Control Panel.
•
Engage the tabs into the Control Panel slots, then
press down on the top of the Thermometer to snap it
into place.
•
Repeat this step for each Thermometer on your Grill.
1
!!
2
Control Panel
Press DOWN
3
14
Procedure - Installing the new Control Panel
Procedure - Replacing your Side Burner - Side Burner Removal
If your Grill
DOES NOT
have a Side Burner - you are almost done. Please skip to Page 11 and perform the leak check
procedure.
If your Grill
DOES
have a Side Burner we need to show you how to replace it.
You will recall from Step 5 that you disconnected the Side Burner Quick-Connect fitting - leave it disconnected.
Please note that the Side Burner lid will not be shown for clarity.
•
First - remove the Side Burner Grate.
•
Next - unplug the Ignitor Electrode Wire from the
Side Burner Electrode by hand. You may need to
hold the Electrode with one hand while pulling the
Wire away with the other hand.
1
The tip must be visible!
You will begin the Side Burner replacement procedure by removing the old Side Burner.
At this point - you should have previously disconnected the Quick-Connect fitting and removed the Control Knobs and
Bezels.
Phillips Screwdriver
7/16” Socket
Tool (Included)
Small bucket or cup
Soft Bristle Brush
Liquid Soap
© Saber Grills, LLC
Printed in U.S.A.
sabergrills.com
80028080
●
09/13/17
●
Revision 03
