Assembly and operating manual
rtv.sabaj.pl/en/home/
(II) -
DOWN
(2 beeps)
d. Press & hold
SETUP button
for about 2 seconds until the
red SETUP led
is off.
The controller is now in normal operation mode.
NOTE:
The programmed buttons of the remote control will be active at the same time for the
device operated by this remote control. The lift can be operated by more than one remote control.
The preferred ranges of motion will be the same for all pilots.
Setting favorite position
Using the programmed remote control, you can set the maximum ranges of motion:
a. Press & hold
SETUP button
for about 2 seconds
–
red SETUP led
will be lit and
you will hear 2 short "beep" signals. You are in SETUP mode.
b. Press the
DOWN button
to set the position. Press the
DOWN button
again to stop
the lift. If you do not stop the lift with DOWN button, it will automatically stops at the
lowest position when the lower limit switch is reached.
c. Press
RC-SET button (
You will hear intermittent beeper signal) and press the
DOWN button
. You will see this
symbol on the display. The down position has
been set.
d. Press the
UP button
to set the position. Press the
UP button
again to stop the lift.
If you do not stop the lift with UP button, it will automatically stops at the highest
position when it reaches the up limit switch.
e. Press
RC-SET button (
You will hear intermittent beeper signal) and press the
UP
button
. You will see this symbol on the display . The up position has been set.
f.
After you are done with all the settings, simply leave the SETUP mode by pressing
& holding the
SETUP button
for about 2 seconds, until the red SETUP LED light
will go off. The preferred positions are now set and the controller is in normal
operation mode.
15.
Reset settings:
It is possible to reset all the favorite positions. To reset the lift press & hold
SETUP button for about 5 seconds. Control box will confirm resetting by short "beep" signal
and showing you this symbol on the digital display: After resetting the lift, it will move
substantially slower until it will reach the marginal positions, to calibrate itself.
16.
Troubleshooting:
The table of symbols on the digital display should also be used as a
troubleshooting guide. Always check, if the green POWER led light is on
– this signals,
that the control box is powered. When you put the plug to the socket, you will hear the
beeper sound, and the green led will be turned on. If the LED is not on, the problem might
be with the control box fuse breakdown, or there is no power in the socket.
