MOBILIFT ECO 650
20
Lift operating – control
Every control box with RF function is delivered with a pre-progammed RF Remote. Only Sabaj RF
remotes can operate with Sabaj control boxes. The buttons on the RF remote control are pre-
programmed and cannot be changed (fig. 11).
The control box has 2 levels of setup.
SETUP mode
is acquired by pressing & holding the
SETUP button
, and is signalized by a
RED
SETUP LED light
.
Motion MEMORY mode
is acquired by pressing the
RC-SET button
. You will hear short beeping
sound.
13.
Programming a new RF remote (optional):
The control box can store up to 8 different RF
remotes. To program a new RF remote:
a.
Press the
RC-SET button
. You will see this symbol on the digital display
b. Press & hold for about 2 seconds any button on the RF remote. Properly
programmed remote will result with the digital display symbol disappearing, and a
short beep
.
NOTE:
Pressing and holding the RC-SET button for 5 seconds deletes all registered RF remotes.
14.
IR-Multicode - IR Remote Setup (optional - requires the purchase of an IR-EYE
accessory):
The IR-Multicode system allows you to use any infrared remote control of the
most popular TV screen manufacturers. You can program the remote control with which
you control your TV working in RC-5 Coding. Some newer remotes work on a Wi-
Fi/Bluetooth and, although they might look like a standard remote, they use a completely
different wavelength
– not using the IR receiver. Please be advised, that
you will need the
IR-EYE Sabaj Accessory connected to the controller via the RJ-45 socket to operate
your lift with an IR remote
.
Due to monostable operating mode it is not recommended to use infrared remote.
To start acquiring the IR remote:
a. Press & hold
SETUP button
for about 2 seconds
–
red SETUP led
will be lit.
b. Press
RC-SET (Memory) button
once - you will hear constant short beep signals.
Then press
SETUP button
– beep signal will stop. You will see this symbol on the
display: . The control box is now awaiting IR signals.
c. Aiming your remote towards the IR-Receiver, press
2 buttons
you want to use for
controlling the lift. Every properly received button will be confirmed by short pauses.
Number of pauses correspond to the button set:
(I) -
UP
(1 beep)
fig. 11
up
down
