• Clean the dispenser using a brush and warm water.
Cleaning the drawer housing
Use a bottle brush to remove detergent residues inside the
drawer housing.
Cleaning the water inlet filter
Use pointed nose pliers to withdraw the plastic filter. Clean, put
back and secure. These filters should be checked every 6 months
or so, or more often if there are frequent interruptions to the
water supply.
Note:
The filter must be put back in place after cleaning.
Cleaning the drain pump filter
1. Disconnect the
machine from the mains
electricity supply and
open the lower cover
with a screwdriver.
2. Place a container under
the pump Unscrew and
remove the filter.
3. Clean the filter care-
fully.
Note:
The filter should be cleaned every 2 months or so,
or when there is fault that the “E03” is on the screen.
Important:
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and position
the end of this hose and that of the inlet hose in a bowl. Run
the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure
that the room temperature is above 0°C.
71
70
GB
GB
