1mm
1mm
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Finishing
Washer M2.5
(H0255-S)
Finishing
Washer M2.5
(H0255-S)
MOTOR BELT TENSION
*Fit the motor assembly into position.
*Move it to the minimum centre distance.
*First put the belt on the motor pinion.
*Then put the belt around the big pulley.
*Rotate the motor several times by hand.
*Pull on the motor mount to tension the belt.
*Rotate again the motor several times by hand.
*Provide the correct force, and properly tension the belt.
*Tighten the M4 nuts first, then the (2) M2.5 screws later.
NOTE
You can use a 4-5mm shaft as a lever
to set proper motor belt tension.
Box 1, Bag for page 22
Motor Belt 261mm
(HC588-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
OK
NOTE
Page 22
INSTALLATION OF THE MOTOR
