ADDITIONAL COMPONENTS REQUIRED
*Engine.
*Muffer suited for the engine being used.
*Batteries: 2S/1600-3000mAh.
*Governor unit.
*1 flybarless 3 axis control unit.
*Receiver system.
*1 throttle servo.
*3 cyclic servos.
*1 tail rotor servo.
*6 channel radio control system on 2.4 GHz.
*Fuel.
The assembly process is described in the following chapters.
Each chapter provides you with the box, bag and/or foam
tray numbers you will need for that chapter. The information
is printed in a green box in the upper right hand corner of the
page at the beginning of every chapter.
TOOLS, LUBRICANTS, ADHESIVES
*Generic pliers.
*Hexagonal driver, size 1.5,2,2.5,3,4,5,6mm.
*4mm T-Wrench.
*5.5mm Socket wrench (for M3 nuts).
*8mm Hex fork wrench.
*Medium threadlocker (eg. Loctite 243).
*Strong retaining compound (eg. Loctite 648).
*Spray lubricant (eg. Try-Flow Oil).
*Synthetic grease (eg. Tri-Flow Synthetic Grease).
*Grease ( eg. Vaseline grease ).
*Cyanoacrylate adhesive.
*Pitch Gauge (for set-up).
*Soldering equipment.
Inside the main box:
Box 2: Canopy, Blade Holder, Tank, Fan Case.
Box 3: Boom, Blades, Tail blades, Carbon rod.
Box 4: Mechanical parts in 4 trays:
Tray 1: Main rotor.
Tray 2: Carbon frame and tail rotor.
Tray 3: Transmission.
Tray 4: Main structure.
Box 5: Bags.
Box 6: Carbon parts.
Box 7: Landing Gear, Main Plate, Tank Support.
Inside the main box there are:
Tray 1
Tray 2
Tray 3
Manual
BOX 6
BOX 7
BOX 2
BOX 4
BOX 5
BOX 3
Tray 4
Page 2
Chapter 3, Components and Box
