Cut
Magnet
BAG 7-4
INSTALLATION OF THE RPM SENSOR
On the Goblin, you can use two different solutions to install
an RPM sensor. The first is a backplate sensor, please look
at the following pictures for how to install it.
P.S:
Not all YS engines can support this style of sensor,
please check with your specific engine.
The second is to use two magnets on the fan.
Please install it in this way:
Install 2 magnets on the fan with epoxy glue ( before, clean part with some degreaser
[ Fig. 4 ]
).
You have to cut open a small slot on the fan case.
[ Fig. 5 ].
To install the sensor, you can use the two M2.5 holes
[ Fig. 6 ]
.
Not all sensors are the same, so you can adapt the position with the carbon support (H0729).
With the Align sensor and the Spartan sensor, you can use the part of the support that already has holes in it.
With any other sensor, you can use the part without holes and adapt as needed.
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
Magnet
H0729-S RPM Sensor Support
Fan case p/n: H0663
Sensor
Chapter 8, Engine Unit Assembly
Page 13
