FLYBARLESS CONTROL UNIT AND RX INSTALLATION
Figures 1
shows an example of installation of the flybarless control unit.
You can use short spacer H0727 (
Figures 2
).
You can use long spacer H0043 (
Figure 3
). This is typical if you want to install RX satellite under the control unit.
For Flybarless systems with a separate sensor, the sensor must be installed under the main plate (
Figure 4
).
Slot for
sensor cable
It is important to lock the plugs of the
flybarless unit with an adhesive - for
example hot glue.
Tail servo extension cable
To install a one piece Flybarless system it is necessary to add the support shown in these figures.
Figure 3 shows the installed support. Figure 4 shows the control unit and the receiver installed on the support.
Support
Flybarless
(H0077-S)
Spacer Support
Flybarless
(H0727-S)
BATTERY and CONNECTION
RX
Flate Head Cap
Screw M3x8mm
(HC134-S)
[H0043]
Socket Head Cap
Screw M3x6mm
(HC044-S)
FBL Unit
Socket Head Cap
Screw M3x6mm
(HC044-S)
Double-sided
Tape
BAG 9-1, BAG 9-2
If you want to assembly RX under FBL
support. You can use H0043 [ 26mm ].
Use the surface in front of the fan case to mount the RX battery. We suggest 2000/2500 mAh (
Figure 5
).
Use the carbon wire support to carry all of the wires between the engine unit and the control unit
( Figure 6
).
Page 19
Chapter 10, Installation Of The FBL and RX