32 025 688 5
Saab 9-5 4D M06-
15 Remove the cellular block from the bumper shell
(wedged into the protective shell's mounting
wedges).
16 Drill 31 mm holes (x4) in the pre-punched mark-
ings in the bumper shell.
17 File out the guide groove 1 x 1 mm. The guide
groove must be on the side of the hole facing the
left-hand side of the bumper shell.
18 Fit the distance sensors in the holders and then
in the bumper shell.
19 Pre-route the wiring harness in the centre foam
section. The connector comes out on the left-
hand side. Connect the wiring harness to the
sensors.
20 Fit the connector's holder to the left-hand side of
the bumper rail.
21 Fit the connector in the holder.
22 Fit the cellular block with wiring harness in the
bumper shell.
23 Guide the bumper rail in toward the bumper
shell's guide pin. Fit the bumper rail with any
reinforcements to the bumper shell.
24 Fit the remaining cellular blocks.
Important
Do not file too far! The cover would then not be
over the guide.
WARNING
Check that the wiring harness is not pinched.
Incorrect fitting can damage the wiring harness
and cause a short-circuit/fire.
E930A403
16
20
18
15,22
19
