355 JUST FOR KIDS
Assembly Instructions
Page 18 of 25
2.6. Just for Kids Rail to Adjusting Tube Assembly
This procedure will require at least two (2)
qualified
persons.
Children
or
other
unqualified personnel should at no time
undertake any part of this procedure.
The length of the Just for Kids Adjusting Tube you are
working with will vary depending on the Just for Kids product
that you are assembling. However, the procedure for
assembling rails and adjusting tubes is the same for all
products.
1. Locate one (1) rail and two (2) Adjusting Tubes.
If you are assembling Just for Kids Uneven
Bars, ensure that the Adjusting Tube you select
are equal in length when assembling each of
the 2 rail heights.
2. Remove the Nylock Nuts and mounting Bolts from the
rail U-bracket located on the end of each rail.
3. Working with one (1) Adjusting Tube at a time, place the rail pivot, which is located at one end of the
Adjusting Tube, into the U-bracket. See Fig. 10 below.
The locking holes in the Adjusting Tube must
face to the outside (end of the rail).
4. Align the hole in the rail pivot with the one in the U-bracket and insert the mounting Bolt through these
holes. Install the Nylock nut with the nylon ring facing away from the U-bracket.
5. Tighten the Nylock & bolt snug, but don’t over tighten. A small space between the U-brackets and rail pivot
need to allow for the bar to flex. See Fig. 10 below.
When tightening the nut and bolt, the Nylon Ring in the Nylock nut must be past the end of the
threads of the bolt to ensure that the nut won’t come loose.
6. Repeat steps 3 to 5 with a second Just for
Kids Adjusting Tube at the opposite end of the
Rail.
7. If you are assembling Just for Kids Parallel
Bars or Uneven Bars, repeat Steps 1 through
6 with the other Rail and Adjusting Tubes.
Fig. 10
