355 JUST FOR KIDS
Assembly Instructions
Page 13 of 25
2.4. Just for Kids Complete System Base Tie-Down - 355-CS
This part requires (1) Just for Kids 4-Station Circuit Base (#355-154) & (4) Just for Kids Single
Bases (#355-01). Since the Just for Kids 4-Station Circuit comes with (1) Just for Kids 4-Station
Circuit Base & (8) Just for Kids Single Bases, you will have (4) Just for Kids Single Bases left
over by choosing this layout.
SA SPORT RECOMMENDS THAT THE JUST FOR
KIDS 4-STATION CIRCUIT BASE & THE JUST FOR
KIDS SINGLE BASES BE BOLTED TO THE FLOOR.
They have been designed and supplied with the
required hardware for bolting to a concrete floor.
This procedure will require at least two (2)
qualified persons. Children or other
unqualified personnel should at no time
undertake any part of this procedure.
1. Position the 4-Station Circuit Base (#355-154) in the center of the desired location for the
apparatus to be set up. The complete 4-station Circuit uses a floor area greater than 17 feet x
17 feet square.
2. Position the 4 Base Leg assemblies (#355-01), around the 4-Station Circuit Base, as shown in
Fig. 6 on the next page.
3. Beginning with Station #1, install 2 Just for Kids Upright assemblies (#355-05) between the
Just for Kids 4-Station Circuit Base (#355-154) & one of the Just for Kids Single Base (#355-
01). Tighten the clamp (Fig. 4A) on the lower section of each side of the Just for Kids Upright
Assemblies (#355-05) by turning
CLOCKWISE
. This will assist in maintaining the correct width
and alignment.
THE BASES MUST BE PARALLEL TO EACH OTHER TO ALLOW FOR PROPER AND
COMPLETE HORIZONTAL ADJUSTMENT OF THE UPRIGHTS ALONG THE LENGTH
OF THE BASES.
4. Using a measure tape, measure the diagonal corner to corner distance of the bases in Station 1
as shown in Fig. 4 on the next page. If required, loosen the Clamp on the Upright of the Just for
Kids Single Base (#355-01) side and slide the Just for Kids Single Base (#355-01) as required to
even out the diagonal distance. Use diagonal measurements (92-3/8”) to help square up the
bases. When measured, the two diagonal distances should be approximately the same.
5. Then proceed to each of the 3 other stations and install one or two uprights, measure and adjust
the diagonal distance of each base. Once all uprights are installed, take the time to observe your
proposed apparatus layout and ensure that there is sufficient floor space for landing mats. Make
any adjustments in the location at this point prior to proceeding to anchoring the apparatus to the
concrete.
