355 JUST FOR KIDS
Assembly Instructions
Page 11 of 25
2.3. Just for Kids Individual Base Tie-Down - 355-01
SA SPORT RECOMMENDS THAT THE JUST FOR KIDS BASES
BE BOLTED TO THE FLOOR.
They have been designed and
supplied with the required hardware for bolting to a concrete floor.
This procedure will require at least two (2) qualified
persons. Children or other unqualified personnel
should at no time undertake any part of this
procedure.
1. Position the apparatus in the desired location. Align both Just for Kids Bases (#355-01) as
shown in Fig. 4 below.
2. Install 1 or 2 Just for Kids Upright Assemblies (#355-05 previously assembled) between the 2
(#355-01) Bases (Fig. 4). Tighten the clamp (Fig. 4A) on the lower section of each side of the
Just for Kids Upright Assemblies (#355-05) by turning
CLOCKWISE
. This will assist in maintaining
the correct width and alignment. Use diagonal measurements (99-7/8”) to help square up
bases. When measured, the two diagonal distances should be approximately the same.
THE BASES MUST BE PARALLEL TO EACH OTHER TO ALLOW FOR PROPER AND
COMPLETE HORIZONTAL ADJUSTMENT OF THE UPRIGHTS ALONG THE LENGTH
OF THE BASES.
Fig. 4
Fig. 4A
