19
VORTEX OPEN FLUME ASSEMBLY INSTRUCTIONS
1. Assemble the four Curve Section Riser (39) pieces. Fasten the two sections together using the two
bolt locations through the side of the parts as shown in Figure N. The hardware required for the two
side locations is as follows: 3/8”-16 x 4-1/2” Button Head Cap Screw S/S (40), 3/8” Flat Washer S/S
(18), 3/8” Flat Washer S/S (18), 3/8” Lock Washer S/S (22), 3/8” Hex Nut S/S (23).
Follow the same procedure to finish assembling the remaining two sections together.
Do not fully tighten any of the hardware until all of the hardware has been assembled.
Do not over tighten. Be sure to apply anti-seize to all fasteners to prevent galling.
FIGURE N
