9
Mast -
This vertical piece is bolted to the base assembly.
Actuator -
Attached to mast, this part powers the up and down movements
of the hoist.
Rotation Motor Assembly
–
Consists of mounting plate, 24-volt motor and small
gear.
Hub Assembly
–
Consists of hub, bearings, shaft, large gear and mast mounting
plate.
Horizontal Support Arms -
These two support arms connect the mast to the seat
support arm. The longer horizontal support arm (actuator arm) connects to the
actuator and initiates the lifting movements.
Seat Support Arm -
Connects seat to the horizontal support arms.
Seating System -
The seat is manufactured from roto-molded plastic with a stainless steel frame. The
seat comes standard with a seatbelt.
The seatbelt must be used during each use. It is recommended that the seat be rinsed off with fresh
water between each use and cleansed daily with a disinfectant solution of 1:100 dilution of household
bleach to fresh water and then rinsed with fresh water. In the event of a contamination incident such as
patient/user excreta - cleanse seat and seatbelt immediately with the above disinfectant solution. Do not
use seatbelt if it is damaged or becomes worn.
Armrests are included as a standard item on all S.R. Smith hoists. The armrests are designed so they can
be rotated up out of the way during transfer.
This hoist seat assembly is designed to be used exclusively with S.R. Smith aquatic access hoists.
UNPACKING & ASSEMBLY INSTRUCTIONS
REFER TO THE DIAGRAM (page 19) FOR PARTS IDENTIFICATION.
READ THESE INSTRUCTIONS IN THEIR ENTIRETY BEFORE UNCRATING THE SPLASH!
Prior to opening the pallet, inspect the external condition for any visible damage. It is important
that any damage be noted on the Bill of Lading. Immediately notify S.R. Smith or your Authorized
Reseller of missing or damaged parts.
Ensure mounting anchor has been installed in the correct location in the pool deck for proper
hoist operation. It is recommended that the anchor be installed by a person familiar with installing
pool deck equipment.
The Splash!
is shipped on a covered pallet and is VERY HEAVY. You will need the following tools for
unpacking and assembly:
•
3/4” or 19mm socket wrench
•
9
/16” or 14mm socket and 9/16” or 14mm wrench
•
small flat blade screwdriver
•
knife or cutters to cut shrink-wrap/bands
Unpacking & Assembly Procedure for the Splash!
1. Cut open enclosure bag around the pallet - carefully remove plastic.
4-Button Hand Control
