10
2. Cut bands around components.
3. Remove the accessory box and seat assembly. DO NOT remove housing cover. It is attached to
the base.
4. Lift the base unit and insert it into the deck anchor using the metal handle located on the top of the
Housing. DO NOT LIFT BASE UNIT USING PLASTIC HOUSING. Make sure that the tab located
on the side of the Splash! base is aligned with the threaded tab in the LiftLock2 deck anchor. Use
t
he 3/8” hex bolt, lock washer, and flat washer to secure the Splash! base to the LiftLock2 anchor.
If you are installing the hoist in a pre-existing anchor that does not include a threaded tab, contact
S.R. Smith for information on a retrofit kit. Once the hoist base has been placed into the deck
anchor, unfasten the nuts and remove and discard the metal handle.
5. Position the mast assembly onto the housing cover by lowering the mast base onto the studs
protruding from the housing. Attach the washers and lock nuts onto the studs and fully tighten
using a 3/4” or 19mm socket wrench. Slide attachment cover to cover the bolts.
6. Remove plastic from mast assembly. Remove 3/
8” (10mm) bolt and nut from actuator arm end.
Following the illustration - attach actuator end to end of actuator arm using the same 3/
8” (10mm)
bolt and nut. Fully tighten bolt and nut using 9/16
” (14mm) socket and wrench
.
Deck to Water Edge
LiftLock2 Anchor
Tab
Splash Base Tab
