www.srsmith.com
Code Adjustments
If it is necessary to change the transmission code on the RM6000, an adjustment to the receiver AND the transmitter DIP
switches must be performed.
RECEIVER DIP SWITCHES- Remove the receiver from the illuminator by sliding the tray out and unplugging the two six-pin
connectors. Remove the four screws that attaches the bottom panel to the top cover. Remove the top cover to expose receiver
PCB and dip switch. Refer to FIG. C to locate the DIP switch panel.
TRANSMITTER DIP SWITCHES- Remove the 6 screws to expose the remote PCB. Refer to FIG. D to locate the DIP switch
panel. Do not discard the rubber gasket.
DIP SWITCH ADJUSTMENT- The four DIP switches have an ON and an OFF position. The default position is all four
OFF. Changing just one DIP switch to ON will change the code. MAKE SURE BOTH THE RECEIVER AND TRANSMITTER
HAVE THE SAME DIP SWITCH SETTINGS.
DIP SWITCH PANEL
DIP SWITCH PANEL
FIG. C
RECEIVER
FIG. D
TRANSMITTER
FIG. E
DIP SWITCH PANEL
