14
13. Remove the battery from the accessory carton and carefully attach to controller.
14. Insert actuator cable (green label) into connector #2 on the Control Box. Make sure the plug is secure
and fully seated.
15. The 24V motor cable will be secured to the mast in
step 18
. For the moment, simply string it through
the housing mast hole. Plug the 24V motor cable (red stripe) into connector #1 on the Control Box. Make
sure the plug is secure and completely seated.
Allow the 24V motor cable to hang freely and untangled
from the first pre-installed clip.
16. Remove the hand control from the accessory
carton. Insert plug into large connector on the
Control Box aligning the key way of the plug.
17. With the battery connected and the 24V Motor
plugged in. Rotate the lift using the right arrow so
that the white plastic wire clips attached to the
mast
face forward. Next, unplug the 24V motor
cord from the controller.
18. To secure the motor cord, follow the steps in the figures below -
24V MOTOR
HAND CONTROL
ACTUATOR
