11
The PAL2 is shipped on a covered pallet and is
VERY HEAVY
. You will need the following tools for
unpacking and assembly:
•
3/4” or 19mm socket wrench
•
9/16” or 14mm socket and 9/16” or 14mm wrench
•
small flat blade screwdriver
•
knife or cutters to cut shrink-wrap/bands
•
claw hammer
Unpacking & Assembly Procedure for the PAL2
1. Cut open enclosure bag at base of unit - carefully remove plastic.
2. Cut internal bands
– remove mast assembly, seat assembly and housing. Lift assembly by mast and
seat arm.
Do not lift mast assembly by actuator as this could damage the actuator
.
3. Remove accessory box.
4. Remove the PAL2 handle from the frame.
5. Roll the main frame from the pallet, across the top of the concrete weights. Position main frame close
to pallet and lock both rear casters.
6.
Counter Weights and Weight restraint belts.
The concrete weights for the lift are located in the bottom of the pallet. Using the claw hammer, remove
the wood restraints to gain access to the blocks. In the accessory carton are the two black belts used for
restraining the weights. Follow the images below to properly install the belts and concrete blocks.
Each concrete weight is approximately 33 lbs /13.6 kg.
Weights leave the factory in good condition; however, they may have shifted during shipping. Inspect the
weights prior to installation to be sure there are no cracked or broken blocks. DO NOT USE DAMAGED
WEIGHTS. Contact S.R. Smith at (800) 824-4387 for replacement.
Use caution when lifting the weights, until they are in their final position, mishandling can crack or break
the weight.
IMAGE 1
IMAGE 2
Lace the belts through the frame, as shown in
image 1
. Place the outer most blocks in position, as shown
in
image 2
and pull the slack out of the restraint belts.
