Lightweight compact parachutes such as the S.E.A. Paragliders WTF are better suited for Runa harness. It is best to
leave the rescue parachute installation to an experienced instructor or harness manufacturer's representative. It is
very important that the rescue parachute is repacked shortly before being installed in the harness - this directly
affects the safety of the pilot.
1. Place the inner reserve parachute container with the tied handle next to the harness container. Make sure the
harness and parachute bridles are not twisted. When installing the reserve make sure the reserve handle is up and
the reserve lines are facing down.
2. Guide the Y-bridles of the harness through all covers from the shoulder straps to the rescue parachute position-
ing on the harness.
3. After installing the parachute into the harness, the harness container must be closed with the pins on the
reserve parachute handle. To do this, use the two special packing devices (included in the harness kit), which are
threaded through two loops on the bottom flap of the outer container.
INSTALLATION THE RESCUE PARACHUTE
4. Close the top flap.
5. Close the left flap (in the
flight direction).
6. Close the right flap (in the
flight direction).
7. Pass the lower pin of the
parachute handle through the
lower loop and the upper pin
through the upper loop.
8. Remove the packing
devices carefully and slowly.
10
9. Pass the plastic cover on
the right side flap through
the parachute handle and
put it into the corresponding
pocket on the left side flap (in
the direction of flight).
