![background image](http://html1.mh-extra.com/html/ryobi/ry80930/ry80930_operators-manual_1506093019.webp)
Page 15 — English
Clean the air filter.
Extend the starter grip and rope rope to check its condi-
tion. If the rope is frayed, have it replaced immediately
by an authorized service center.
Remove all hoses. Coil the hoses and store as shown.
Do not allow the hose to become kinked.
Store the unit and accessories in an area that does not
reach freezing temperatures. Do not store near furnace or
other sources of heat that could dry out the pump seals.
PREPARiNG FOR USE AFTER STORAGE
Pull the starter grip and rope grip three or four times to
clean lubricant from the combustion chamber.
Remove spark plug from the cylinder. Wipe oil from the
spark plug and return it to the cylinder.
Reconnect the spark plug wire.
Refuel the machine as described earlier in the operator’s
manual.
NOTICE:
The use of a pump protector is strongly recommended
after each use and before storing to prevent cold weather
and seal damage during storage.
Drain the lubricant and replace with fresh, clean lubricant
as described in the engine manual.
Disconnect spark plug wire and remove the spark plug.
Pour about a teaspoon of clean, air-cooled, four-cycle
oil through the spark plug hole into the combustion
chamber.
Leaving the spark plug out, pull the starter cord two or
three times to coat the inside of the cylinder wall.
Inspect the spark plug and clean or replace, as necessary.
Reinstall the spark plug, but leave the spark plug wire
disconnected.
MAiNTENANCE
PERiOdiC MAiNTENANCE SCHEdULE TABLE
NOTE:
If a separate engine manual is provided for this pressure washer, please follow the maintenance schedule provided
in the engine manual for all engine maintenance items instead of the maintenance information listed below.
Maintenance
Items
Each Every Every Every Every Every
use
8 hrs.
20 hrs.
50 hrs.
100 hrs.
300 hrs.
Clean engine & check bolts & nuts
X
X
Check engine lubricant
X
Change engine lubricant
1
X
Check water inlet filter placement
2
X
Add fuel stabilizer
X
Add pump protector
X
Clean spark plug
X
Clean air cleaner
X
X
Replace air cleaner element
X
Clean & adjust spark plug & electrodes
X
Replace spark plug
X
Remove carbon from cylinder head
3
X
Check & adjust valve clearance
3
X
1
Initial lubricant change should be performed after the first 20 hours of operation. Do not pour old lubricant down
sewage drains, into garden soil, or into open streams. Your local zoning or environmental regulations will give you more
detailed instruction on proper disposal.
2
If water inlet filter is missing or damaged, it must be replaced. See Replacement Parts List for part number to order.
3
Have performed by your nearest service center