Page 11 – English
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Wear head protection when
operating this equipment above shoulder level. Failure
to do so could result in objects being thrown into your
eyes and other possible serious injuries.
WARNING:
Before inspecting, cleaning, or servicing the machine,
disconnect the plug from power source and wait for all
moving parts to stop. Failure to follow these instruc-
tions can result in serious personal injury or property
damage.
GENERAL MAINTENANCE
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not operate
this product until all missing or damaged parts are replaced.
Please call 1-800-860-4050 or contact an authorized service
center for assistance.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
WARNING:
Blades are sharp. When handling the blade assembly,
wear non-slip, heavy-duty protective gloves. Do not place
your hand or fingers between blades or in any position
where they could get pinched or cut. NEVER touch blades
or service unit with the power supply connected.
LUBRICATING THE BLADE
See Figure 9.
For easier operation and longer blade life, lubricate the hedge
trimmer blade before and after each use.
Stop the motor and disconnect plug from power supply.
Lay the hedge trimmer on a flat surface. Apply light weight
machine oil along the edge of the top blade.
If you will be using the hedge trimmer for an extended period,
it is advisable to oil the blade during use.
NOTE: Do not oil while the hedge trimmer is running.
Stop the motor and disconnect plug from power supply.
Lubricate the hedge trimmer as described above.
Reconnect plug to the power source and resume use.
SHARPENING THE BLADE
See Figure 10.
Allow the blades of the hedge trimmer to come to a stop
in the position shown. This will allow clearance for the
file between the cutter teeth and the guard teeth.
Disconnect the plug from the power source.
Clamp the blade assembly in a vise and file the exposed
cutting surface of each blade tooth with an 8 in. smooth
round file, 1/4 in. or 7/32 in. in diameter. Be sure to retain
the original angle of the tooth when filing.
Remove the hedge trimmer from the vise, reconnect plug
to the power source, and restart the hedge trimmer. Al-
low the blades of the hedge trimmer to come to a stop
so that the unsharpened edges on the other side of the
cutter blade teeth are exposed.
Disconnect the plug from the power source and repeat
the sharpening procedure as described above.
CLEANING THE HEDGE TRIMMER
Stop the motor and disconnect plug from power supply.
Clean dirt and debris from the body of the hedge trimmer,
using a damp cloth with a mild detergent.
NOTE: Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils such as pine and lemon, and by solvents
such as kerosene.
TRANSPORTING AND STORING
See Figure 11.
Always place the blade cover on the blade before storing
or transporting the hedge trimmer. Use caution to avoid
the sharp teeth of the blade.
Clean the hedge trimmer thoroughly before storing. Store
the hedge trimmer indoors, in a dry place that is inacces-
sible to children. Keep away from corrosive agents such
as garden chemicals and de-icing salts.
MAINTENANCE