Ryobi RY408010, Operator'S Manual

Page: 11 / 36

11 — English
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which can result in serious personal injury.
˝

Maintain or replace safety and instruction labels, as
necessary.
LUBRICATION
All of the bearings in this product are lubricated with a suf-
ficient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
bearing lubrication is required.
STORING THE SNOW BLOWER
See Figure 11.
CAUTION:
Ensure all melted snow that may drip from the snow blow-
er is properly wiped up to prevent a slip and fall hazard.

Remove the batteries and store in a secure location out
of the reach of children.
MAINTENANCE

Before storage, wipe any moisture, dirt, or debris from the
battery area.
 Wipe the snow blower with a clean dry cloth.
˝

Check all nuts, bolts, knobs, screws, fasteners, etc., for
tightness.
˝  Inspect moving parts for damage, breakage, and wear.
Have repairs made on any damaged or missing parts.

Unlock the handle lock levers and fold the upper handle
to the storage position. Return the levers to the locked
position.
NOTICE:
Do not allow the cable to become pinched or trapped
when lowering the handle.

Store snow blower indoors in a clean, dry place out of
the reach of children.

Do not store near corrosive materials such as fertilizer or
rock salt.
REPLACING THE SCRAPER
See Figures 12 - 14.
The scraper may need to be replaced when a layer of snow
remains on the ground after making a pass. To order, call
customer service and ask for part number 537724001.
 Remove the 4 screws from one side panel with a T20 Torx
screwdriver (not included) and set aside.

Repeat for the other side.
 Tilt the unit forward as shown to allow access to the
screws for the scraper.

Remove the 7 T20 screws from the scraper. Discard the
old scraper.
 Install the new scraper and reinstall the screws.
NOTE: Make sure all screws are tightened securely. Do
not overtighten.
 Reinstall the side panels and screws on both sides.