Ryobi RY14122, Operator'S Manual

Page: 16 / 56

12 — English
NOZZLE SELECTION GUIDE
HIGH PRESSURE
(NO SOAP WHEN USING THESE NOZZLES)
LOW PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Turbo Nozzle
15º
Blue or Black
Soap Nozzle
Concrete, Brick, Masonry
  
Siding, Gutters, House
 
Fencing, Deck, Patio
 
Lawn Equipment, Boat, RV
 

Recommended Nozzle

Use With Caution for Certain Applications
OPERATION

Push the nozzle into place in the spray wand.

Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
To disconnect a nozzle from the spray wand once the
cleaning job is complete:

Turn off the pressure washer and shut off the water supply.
Pull trigger to release water pressure.

Engage the lock-out on the trigger handle by pushing up
on the lock-out until it clicks into the slot.

Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle storage area on the trigger handle.
USING THE HIGH PRESSURE HOSE
WARNING:
Injection hazard. Fully unwrap and straighten high
pressure hose prior to and during each use and do
not allow it to become kinked. The high pressure hose
features an outer covering that provides strength to the
hose. If the outer covering becomes damaged, stop using
the hose and replace it immediately. A kinked or damaged
hose can develop a high pressure leak and result in a
possible injection or other serious personal injury.
To prevent damage to the outer covering:

Inspect the hose before every use.

Fully unwrap and straighten hose before use.

Do not allow the high pressure hose to be kinked.

Keep hose away from hot surfaces and sharp edges.

Do not pull unit by high pressure hose.

Do not allow hose to be crushed or wrapped around
objects.