10
ENGLISH(Original Instructions)
TROUBLESHOOTING
Problem
Possible Cause
Solution
Pressure washer
does not start
when trigger is
depressed
Power cord not connected to
power source
Switch is off
House circuit breaker is tripped
Connect the power cord to a live 220-240V AC, 50 Hz AC
plug.
Turn switch on.
Reset house breaker. Make sure pressure washer is
connected to an individual branch circuit only. If using an
extension cord, make sure it is heavy enough to carry the
current of the pressure washer.
Pump doesn’t
produce pressure
Inadequate water supply
Spray lance leaks
Nozzle is clogged
Pump is faulty
Air in line
Water inlet filter is clogged
or dirty
Provide adequate water flow.
Check connections and / or replace lance.
Clean nozzle.
Contact authorized service centre.
Squeeze trigger on gun to remove air from line.
Remove the water inlet filter, rinse with warm water, then
replace in unit.
Machine doesn’t
reach high
pressure
Diameter of garden hose is
too small
Water supply is restricted
Not enough inlet water
Replace with 12mm garden hose.
Check garden hose for kinks, leaks, and blockages.
Open water source full force.
No detergent
Detergent tank is empty
The detergent dial is not
completely in the ON position
Water supply is inadequate or
clogged
Add additional detergent to tank.
Turn the detergent dial fully to the ON position.
Check garden hose for kinks, leaks and blockages.
DISPOSAL
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
RPW120X manual.indd Sec2:10
RPW120X manual.indd Sec2:10
09-12-15 9:22
09-12-15 9:22
