9
ENGLISH(Original Instructions)
machine, shut off motor, wait for all moving
parts to stop, and disconnect plug from power
source. Failure to follow these instructions can
result in serious personal injury or property
damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, petrol,
petroleum based products, penetrating
oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy
plastic which may result in serious personal
injury. Only the parts shown on the parts list
are intended to be repaired or replaced by the
customer. All other parts should be replaced at
an authorized service centre.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service centre in order to
avoid a safety hazard.
NOZZLE
MAINTENANCE
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or
dirty nozzle.
■
Unplug the pressure washer.
■
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
■
Remove the nozzle from the lance.
NOTE:
Never point the spray lance at your face.
■
Using a straightened paper clip or nozzle cleaning
tool, free any foreign materials clogging or restricting
the nozzle.
■
Using a garden hose, clear/flush debris out of nozzle.
■
Reconnect the nozzle to the lance.
■
Turn on the water supply.
RPW120X manual.indd Sec2:9
RPW120X manual.indd Sec2:9
09-12-15 9:22
09-12-15 9:22
