11
oPErATIon
rEPlACInG CuTTInG lInE In SPool (Fig. 13)
Use 2.0mm diameter round nylon line.
1. Remove the thread spool, and remove any old line remaining on the spool.
2. Bend a new thread in the middle, and hook into the spool. (Fig.13-A)
3. Place the thread cover on the spool, and make sure the two lines are captured in the slot opposite each other on
the thread cover. (Fig.13-B)
4. Hold the thread cover tight and wind the thread spool in the counterclockwise direction until leaving 15cm
extended beyond the slot. (Fig.13-C)
5. Thread the lines into the eyelets, and pull them extending from the slots on the thread cover. (Fig.13-D)
6. Reinstall the spool cover by depressing tabs into slots and pushing down until the spool cover clicks into place.
CAuTIon:
Pay attention to the winding direction.
Fig. 13
A
B
C
D
Summary of Contents for RLT-800
Page 1: ...6986295 STD 06 11 RLT 800 ...
Page 4: ...3 ...
Page 14: ...13 NOTES ...
Page 15: ...14 NOTES ...