background image

14

EnGLISH (Original Instructions)

PROBLEM

POSSIBLE CAUSE

REMEDY

Engine will not start.

No spark.

Clean or replace spark plug. Reset spark plug gap. Refer 

to Spark Plug Replacement earlier in this manual.

No fuel.

Push primer bulb until bulb is full of fuel. If bulb does 

not fill, primary fuel delivery system is blocked. Contact 

a servicing dealer. If primer bulb fills, engine may be 

flooded, proceed to next item.

Engine is flooded.

Remove spark plug, turn hedge trimmer to aim spark 

plug hole at the ground. Adjust the choke lever to “RUN” 

position and pull starter cord 10-15 times. This will clear 

excess fuel from the engine. Remove any fuel which is 

splashed  on  the  unit.  Clean  and  reinstall  spark  plug. 

Clean up any spilled fuel and move at least 9m away 

before restarting. Pull starter cord 3 times with choke 

lever at “RUN” position. If engine does not start, rotate 

choke  lever  to  “COLD  START”  position  and  repeat 

normal starting procedure. If engine still fails to start, 

repeat procedure with a new spark plug.

Starter rope is harder to pull 

now then when new.

Contact a servicing dealer.

Engine  starts  but  will  not 

accelerate.

Engine requires approximately 

three minutes to warm up.

Allow engine to completely warm up. If engine does not 

accelerate after three minutes, contact a servicing dealer.

Engine  starts  but  will  only 

run  at  high  speed  at  half 

choke.

Carburetor requires  adjustment. Contact a servicing dealer.

Engine does not reach full 

speed and emits excessive 

smoke.

Check lubricant fuel mixture.

Use fresh fuel and the correct 2-stroke lubricant mix.

Air filter screen is dirty.

Clean air filter screen. Refer to Cleaning The Air Filter 

Screen earlier in this manual.

Spark arrester screen is dirty.

Contact a servicing dealer.

Engine  starts,  runs,  and 

accelerates but will not idle.

Idle speed screw on  carburettor 

needs adjustment

Turn idle speed screw clockwise to increase idle speed. 

See figure 11. The blades should not move at idle.

EMISSIONS MAINTENANCE SCHEDULE AND  WARRANTED PARTS LIST

  Emissions Parts  Inspect Before   Clean Every 

Replace  

Clean Every  Replace Every 

 

Each Use 

5 Hours 

Every 25 Hours    25 Hours  

50 Hours 

 

 

 

or Yearly 

or Yearly

CATALYST MUFFLER ASSEMBLY ...................................................................................................................... X

AIR FILTER ASSY

  Includes:
  Filter Screen ..................................................... X
SPARK SCREEN .................................................................................................................................................X
FUEL TANK ASSY

  Includes:
  Fuel Lines ........................ X
  Fuel Cap .......................... X
IGNITION ASSY

  Includes:
  Spark Plug ........................................................................................ X
ALL EMISSIONS-RELATED PARTS ARE WARRANTED FOR TWO YEARS OR FOR THE PERIOD OF TIME PRIOR 

TO THE PARTS FIRST SCHEDULED REPLACEMENT WHICHEVER COMES FIRST.

TROUBLESHOOTInG

Summary of Contents for RHT2660DAG
















Reviews: