9
OPERATION
The compressor continues to operate according to
this automatic cycle until the On/Off (I/O) switch is
pressed.
Always wait at least 10 seconds from when the
compressor has been switched off before restarting
this.
OVERLOAD PROTECTION
This compressor is fitted with an overload
protection device, In the event that the motor
becomes too hot a thermal protection device will
cut the mains supply to the motor. When the motor
temperature returns to normal, the mains supply
will be restored automatically.
CONNECTING/DISCONNECTING AIR HOSE
WARNING.
Never exceed the air tool’s
pressure rating as recommended by the
manufacturer. When using this air
compressor as an inflation device,
always follow the maximum inflation
guidelines stated by the manufacturer of
the item being inflated.
Make sure the air compressor is off and
unplugged.
Rotate pressure regulator knob fully in the
counter-clockwise direction so that the outlet
pressure is at zero (0) psi.
Connect a hose to the compressor using the hose
to compressor quick release connector (Fig.3).
Make sure to push the air fitting fully into the
coupler until the sleeve springs forward to lock in
place.
To disconnect an air hose or an air tool:
Confirm that the outlet pressure is at zero (0) psi.
When disconnecting a hose from the quick release
connector, always firmly hold the fitting end of the
hose.
Push back on the release sleeve on the quick
release connector.
With a firm grip, pull out the quick-connect air
fitting that is attached to the quick release
connector.
BREAK-IN PERIOD
Before first use, run the air compressor at zero (0)
tank pressure with the drain valve tap fully open for
30 minutes.
SWITCHING ON AND OFF
WARNING.
Switching On & Off must be
done using the On/Off switch mounted
on the compressor. Switching the
compressor Off at the mains supply can damage
the motor and will invalidate the guarantee.
Before switching on the power supply to the
compressor check that the On/Off switch is in the
Off position (non-depressed) (Fig.4).
Check that the pressure regulator is closed (turned
fully anti-clockwise) (Fig.5).
Fig. 3
Fig. 4
Fig. 5
