25
9.7
CIRCULAR CUTTING GUIDE (Fig. 33)
The circular cutting guide can cut cylindrical workpieces with a diameter of up to 260 mm. This device guarantees you optimal
cuts when it is used with the curve-cutting sawblade.
1. Attach the guide plate with the fastener and screw.
2. Install the compass using the locking part and retaining screw.
3. Place the circular cutting guide in the desired position.
9.8
STORING YOUR SAW
Warning!
Once your saw has stopped, put your saw away so that incompetent people cannot start it up and so that no-one
runs the risk of getting hurt.
Important!
Do not leave the machine outside without protection or in a damp place.
10.
A FEW RECOMMENDATIONS
Keep the surface of the table clean – in particular, remove resin residues with an appropriate spray cleaner.
Then treat the surface of the table with a lubricant.
11.
REPAIRS
Warning!
Only qualified persons are authorised to repair electrical tools. When you send a part or machine for repair, please
describe the defect encountered.
If you have to replace your connecting cable, only use the manufacturer’s cable.
12.
PROTECTING THE ENVIRONMENT
The material used as packaging for your machine is 100% recyclable.
Used electric tools and accessories contain many precious raw materials and plastics that can be recycled.
This manual is printed on chlorine-free paper.
13.
PROBLEMS AND BREAKDOWNS
Warning!
Before any operation on the machine:
•
Unplug the machine.
•
Remove the power plug.
•
Wait until the sawblade has stopped.
After all operations, re-set the safety device and check that it is operating properly.
The motor doesn’t work:
The undervoltage relay was set off by a temporary power cut.
Plug the machine back in.
There is no power supply:
Check the state of the cable, plug, socket and fuse.
The motor is over-heating due to a dull sawblade or to sawdust piling up in the casing:
Remove the source of over-heating, let the motor cool down for a few minutes then plug the machine back in.
GB
Summary of Contents for RBS-5518
